Allows for a custom # of characters to be input and received with the signal translator. Note that the terminal input is also patched, allowing you to input up to 9999 characters. In addition, it needs to be patched for everyone that uses this mod, transmissions received by others will be truncated to 9 without this installed.
The plugin can configure a few settings to enhance the experience of the signal
translator to the user's liking, this is done in the BepInEx config file located
at BepInEx/config/CustomTranslatorCharLimit.cfg. The settings are as follows:
MaxCharLength: The maximum number of characters that can be input into the
translator. This is set to 10 by default, but can be set to any number between
1 and 9999. Default is 10.
MinSecondsToWait: The signal translator transmits characters at random intervals
in between each one, default is from 0.7 to 2.7 seconds. Configuring this option
will change the minimum amount of time to wait in between each character.
Default is 0.7.
MaxSecondsToWait: Similar to above, configuring this option will change
the maximum amount of time to wait in between each character. Default is 2.7.
SecondsToWait: This option will set a constant time to use for the signal
translator's delay per character. This way, every character will come in at the
same time, but it requires the UseRNG option below to be false.
UseRNG: This option will set whether or not to use the random number generator
to determine the delay between each character. If set to false, the SecondsToWait
option will be used instead. Default is true, which uses the bounds set by MinSecondsToWait
and MaxSecondsToWait.
For more help/questions/bug reports, contact me on discord: thegulagisalie
